Chains and sprockets motorcycle of BMC

Chains and sprockets motorcycle with extra filtering on the brand BMC

BMC

With a BMC air filter is a wise choice for your motorcycle. Placing a BMC air filter is simple: remove the original old paper air filter and replace it with the BMC air filter. No modifications to your bike are also needed.

Benefits BMC air filters:

• Better air flow through the larger surface
• Filter material is cotton (original paper)
• Longer life
• Filter can be cleaned and reused (filter lasts longer than the motorcycle, so it never buy a new one)
• Because of the shape of the pressure drop the air passage is reduced to a minimum

Mounting BMC on your motorcycle:

The installation of a BMC air filter on your motorcycle with little technical knowledge.It is a matter of swapping out the original air filter at a BMC air filter. Most of the work will sit before removal and installation of other things to get to the air filter. If you are unfamiliar with this, it earned the recommendation to use technical documentation such as a workshop manual.

Please note that the air filter has been oiled and it is not necessary to address the first spray and is immediately ready for use.

Chains and sprockets motorcycle

The motorcycle chain is a crucial part of transferring power from the motorcycle block to the rear wheel. The most common chain types are the O-Ring and X-Ring. These types differ in the type of rubber sealing ring between the rollers and the side plates. The O-Ring chain is provided with sealing rings that have a round cross-section. Its successor is the so-called X-Ring chain. The cross-section of these seals looks like an X and provides a better seal, so that the lubricant (chain spray) remains better protected in the rollers and therefore better lubrication is guaranteed.

A good chain set is very important for the maintenance of your motorcycle. That is why we sell a chain set from DID with Esjot or JT sprockets. The quality of the chain can be divided into mainly 2 categories, namely the VX, VX2, VX3 or the ZVM-X chain. The VX, VX2 and VX3 chain are of good quality and great for daily use. If you set maximum requirements for your chain, it is advisable to take the DID ZVM-X chain. This chain can withstand very heavy loads (motors with a lot of horsepower and also powerful 2 cylinders that can give a lot of blows). Both chains are safe to use for all motorcycles. Only the service life under heavy load will be longer with a ZVM-X chain.

Mounting chain set motor

The installation of a chain set is a maintenance job that you can easily do yourself. Some technical knowledge is required. In particular, the disassembly and assembly of certain parts, such as the rear wheel, must be done carefully. Make sure that the rear wheel is mounted straight again and that the chain is set to the correct tension. That tension means that the chain must move about 3 cm up and down in a loaded condition. It is therefore important to measure this when someone is on the motorcycle. This prevents the chain from being too tight while driving. Always replace the sprockets when you install a new chain.

Motorcycle chain maintenance

The maintenance of the chain of the motorcycle is a job that should not be underestimated, which can extend the life of your chain considerably. There are mainly two activities that need to be done. The first is to regularly spray the chain with specific chain spray for the motorcycle. Depending on the brand, this differs between 500-1000 km. For example, the S100 chain spray only needs to be used once every 1000 km. In addition to this regular injection, it is advisable to clean the motorcycle chain once a season. The advice is to do this at the end of the season. This is an easy job if you use the S100 chain cleaner. With this you only have to spray the chain, distribute it well with a brush and then spray it off with a hard jet of water after 15 minutes. The clean chain can then be sprayed again with the chain spray.

In addition to keeping the chain set clean, a regular check of the chain tension is necessary. This is a visual check and, if necessary, the chain can be correctly adjusted in the prescribed manner (differs per motorcycle).

The right chain set

To find the right chain set for your motorcycle, you can use the selector. By the way, you can choose other sprockets when ordering. Choose the Custom option and specify the desired sizes in the remark with your order. The options are indicated in the article description of the chain set.